allworx - communications without compromise

Frequently Asked Technical Questions about Allworx

 

Allworx Trunk / PRI / Connectivity FAQ's

  1. What Trunk Start Signaling Type does Allworx use?
  2. What is the Incoming trunk selection sequence?
  3. Does Allworx handle PBX Store & Route Digits?
  4. What is the Phone Switch Type?
  5. What PRI Types are used?
  6. How do you set up Return Dialtone on Seizure?
  7. Who sets up Yield to Glare?

 

 

 

 

 

 

 

What Trunk Start Signaling Type does Allworx use?
TOP

When using CAS/RBS, Allworx handles Wink (Feature Group B only ), Immediate, Loop, and Ground Start trunks.  

Note: E&M Wink Start - Feature Group D (Wink Start with Wink Acknowledge protocol), is not supported.

 

What is the Incoming trunk selection sequence?
TOP

Allworx handles ascending and descending selection only.

 

Does Allworx handle PBX Store & Route Digits?
TOP
Allworx handles from 1 digit to the full number.  The most common setting for DID's is 4 digits (FYI, "store and forward" is used with RBS, not PRI).

 

What is the Phone Switch Type?   
TOP

Allworx IP PBX .

 

What PRI Types are used?   
TOP

Allworx handles:

  • NI-2
  • DMS100 proprietary
  • Lucent 4E & 5E proprietary

 

How do you set up Return Dialtone on Seizure?
TOP

Allworx will do this ourselves, please don't set the switch up to provide that setting.

 

Who sets up Yield to Glare?
TOP

Both sides may/can do that.